This module consists of an L298 motor driver IC and a 78M05 5V regulator. When the power supply is less than or equal to 12V, then the internal circuitry will be powered by the voltage regulator and the 5V pin can be used as an output pin to power the microcontroller. The jumper should not be placed when the power supply is greater than 12V and separate 5V should be given through 5V terminal to power the internal circuitry.ĮNA & ENB pins are speed control pins for Motor A and Motor B while IN1& IN2 and IN3 & IN4 are direction control pins for Motor A and Motor B. This L298N Motor Driver Module is a high power motor driver module for driving DC and Stepper Motors. Two enable inputs are provided to enable or disable the device. It is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors. The L298N Motor Driver module consists of an L298 Motor Driver IC, 78M05 Voltage Regulator, resistors, capacitor, Power LED, 5V jumper in an integrated circuit.ħ8M05 Voltage regulator will be enabled only when the jumper is placed. The L298 is an integrated monolithic circuit in a 15-lead Multiwatt and PowerSO20 packages. L298N Module can control up to 4 DC motors, or 2 DC motors with directional and speed control. Technical specs Operating Voltage 5V to 12V Motor controller L298N, Drives 2 DC motors or 1 stepper motor Max current 2A per channel or 4A max (with external. It uses the popular L298N Dual H-Bridge Motor Driver chip and is powerful enough to drive motors from 5-35 Volts at up to 2 Amps per channel. It is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors. The L298N Dual H-Bridge Motor Driver is a low cost motor driver board that can be used to drive two robot motors. This l298 driver module consists of an L298 driver IC and a 78M05 5V regulator. L298 Motor Driver TheL298 dual full-bridge motor driver board for Arduino/Raspberry-pi,uses double H driver ic L298 which an integrated monolithic circuit in a 15 - lead Multi watt and Power SO20 packages. L298N Motor Driver Module H-Bridge is a high power driver module for driving DC and Stepper Motors.

L298 motor driver specs